T2 network disk mode connection access

2018-06-11

T2 is used as a web disk mode

1. T2 is connected to the power adapter through Micro USB 3.0 cable (power requirement 5V-1.5A or above).

2. Click the power button on the device. At this time, the T2 LED is steady green and the network port is on.

If the disk mode does not read the disk, please make sure whether the hard disk is installed, if the hard disk is available, and the new hard disk needs USB to connect to the computer for initialization.
Please read "Hard Disk Initialization Instructions"

Previous：T2 hardware interface introduction

Next：T2 connects to the computer as a mobile hard drive